Schedule a Call Back
Hot Runner Temperature Controller
Hot Runner Temperature Controller
Adinath Controllers offers RMB Series HOT Runner Temperature Controller, which is a microprocessor-based single-zone temperature controller. It is specifically designed for runnerless molding applications. It features an easy-to-use operator keypad, two LED displays and three discrete indicators for heat-current, alarm and manual mode.
- Input Voltage: 95-265 Vac
- Frequency: 50 Hz ± 3 Hz, 60 Hz ± 3 Hz
- DC Power Supplies: Internal generated, regulated and temperature compensated
- Module Power Usage: Less than 3 watts, excluding load
- Ambient Temperature: 32°F to 999°F (0°C to 537°C)
- Calibration Accuracy: Better than 0.2% of full scale
- Input Type: Potentiometric
- Input Impedance: 10 megohms
- Input Protection: Diode clamp, RC filter
- Input Amplifier Stability: Better than 0.05 °F/°F (0.03°C/°C)
- Input Dynamic Range: Greater than 999°F (537°C)
- Common Mode Rejection Ratio: Greater than 100 dB
- Power Supply Rejection Ratio: Greater than 70 dB
- Output Voltages: 240 Vac nominal, single phase and 120 Vac available
- Power Capability: 15 amperes, 3600 watts @ 240 Vac; 30 amperes, 7200 watts @ 240 Vac
- Power Line: Optically and transformer isolated from ac Isolation lines. Isolation voltage is greater than 2500 volts.
- Output Drive: Internal solid state triac triggered by ac zero crossing pulses
- Display Top: 3-digit filtered LED
- Display Bottom: 4-digit filtered LED
- Status Indicators: Heat-current output Alarm
- Athena’s mainframes are compatible with all D-M-E Company’s G SERIES and SMART SERIES®, ITC, MCS, YUDO® and INCOE® brand mainframes
- Accepts Type J or Type K thermocouple input (jumper selectable)
- Auto-tuning, with adjustable proportional band and rate
- Bumpless auto/manual transfer
- CompuStep® bake out feature prevents moisture at startup
- Built-in loop break, short, open and reverse thermocouple protection
- Built-in triac safety protection
- Ground-fault protection
- Preset alarms at 30° F (17°C)
- Jumper-selectable soft-start mode
- Current monitor feature displays average current to load
- SafeChangeTM “hot swap†feature allows safe removal and replacement of module
- CE compliant
