• Osborn Lippert India Private Limited

Weld Cleaning Power Brush

Osborn Lippert India offers a Weld Cleaning Power Brush (knotted type wheel brush – steel and stainless steel wire), designed especially for the gas and oil pipeline construction industry. It is an aggressive model which runs at high speeds on surfaces for descaling, deburring, removing rust and adhesive residues as well as preparing and cleaning weld seams. Technical Specifications: with the most commonly used Osborn brush of diameter 171 mm and 76 knots, almost 500,000 sharp wire tips per second are applied to the weld seam. This moves over the surface at a speed more than 280 km/hr and thus removes even the smallest contaminants. Applications: these brushes are particularly designed for following areas: weld seam cleaning on fillet welds, in constricted openings and slots; non-stock removing; removal of the coating material, which has been applied as corrosion protection, from the exterior of the pipeline tubes; and the problem zones and undercut that arise under the influence of heat and are normally difficult to reach during welding. The removal of cinder and oxidisation is achieved in a complete and efficient manner. It is an excellent cleaning solution for weld seams prior to re-welding and any welding defects are visible immediately after brushing and can be reworked immediately and an overall improvement of quality standards is achieved. Osborn’s weld cleaning power brush is produced from the highest quality materials, thus providing long life and exceptional brushing results. Productivity of the brush is always in terms of quality. And ultimately it reduces the cost of construction by 30-35%. Depending upon the surface quality required brushes with the correct wire size can be specified. These brushes are available in normal and high density as well. They are easy to install and operate with all mobile as well as stationary machines.