• CNC Servicing & Solutions India Private Limited (Haas Automation)

TOOL ROOM LATHES

Haas Technical Center offers Tool Room Lathes, TL-2. It provides a maximum cutting diameter of 16" and a maximum cutting length of 48". It has a maximum part swing of 19" over the front apron and 11.1" over the cross slide. A powerful 12-HP (peak) vector dual drive spindle spins to 1,800 RPM and provides 150 ft-lb of torque at 125 rpm. On-the-fly wye-delta switching yields a wide horsepower band for constant surface feed cuts. An A2-6 spindle nose is standard, and a 10" scroll chuck is optional. The spindle bore is 3.0". It features a one-piece cast-iron base that damps vibration and provides rigidity for heavy cuts, and an optional manual tailstock and steady rest are available. The machine runs on either single or three-phase power. Operations that would be difficult or even impossible on a manual machine, such as compound angles, radii, tapers, profiles, ID and OD threading and rigid tapping, are all possible on the TL-2 without the knowledge of G-code programming. For extreme versatility, the device operates in four modes. In manual mode, X and Z-axes are moved via manual hand wheels (or the electronic jog handle), with the CNC control providing precise digital read-out (DRO) of position; electronic soft stops may be set to limit the travels of the lathe. In semi-automatic mode, the TL-2 performs dual-axis simultaneous linear interpolation, such as chamfers and tapers, using a single hand wheel, again with accurate, easy-to-read DRO. In automatic mode, the TL-2 has built-in machining cycles for rough and finish profiling, radiuses, chamfering, grooving, threading, drilling and tapping. In full CNC, the TL-2 is programmed using standard G code, and all axes are controlled by the CNC control. The new Turning System software makes the device extremely easy to set up and operate without the knowledge of G-code programming.