Schedule a Call Back
Cyclo Instruments offers Plain Plug Gauges. These are available in the range of 0.5 to 12 mm in reversible gauge element type design. The gauge elements are fastened by collets and nut mechanism to the opposite ends of a handle. When after regular use the gauge element wears off; the same could be unlocked and reversed in position (inside edge out) to put in use the unused intact inside edge. This enables the user to get double life from one single gauge thereby saving on the gauge costs. The gauge elements (pins) are 40 mm in length below nominal diameter of 1.5 mm and are in HSS. The gauge elements (pins) beyond 1.5 mm are made from SAE 52100 steel and are of 50 mm length. All pins are full cylinders over their entire length. 10 mm of the length of the pin is sufficient for holding the gauge pin into the collet. Gauge manufacturing tolerances are as per IS 3455-1971. Very suitable for deep hole inspection; and with the advantage of getting double life due to reversal of the pin end after wearing off, these type of gauges are in good demand from watch makers; electronic and hydraulic industries; jewellery manufacturers; dash board instruments industry; and general engineering industry.
INDUSTRIAL PRODUCTS FINDER (IPF) is India’s only industrial product portal. Referred to as the ‘Bible’ of the manufacturing sector in India,
INDUSTRIAL PRODUCTS FINDER (IPF) is India’s only industrial product portal. Referred to as the ‘Bible’ of the manufacturing sector in India,
Hi There!
Now get regular updates from IPF Magazine on WhatsApp!
Click on link below, message us with a simple hi, and SAVE our number
You will have subscribed to our Industrial News on Whatsapp! Enjoy
Schedule a Call Back