• Productivity Consultants

Electronic Endurance Cycle Tester With Counter

Productivity Consultants offer electronic endurance cycle tester with counter. This tester is useful for quality assurance of the manufactured products as well as the comparison of performance of similar products of the competitors. The electronic endurance cycle tester is also used for R&D as different materials employed for components can be subjected to test for suitable selection. Consider an automobile accelerator cable for example. The cables are mounted on board and placed in such a fashion that they operate in a given vehicle. One end of the cable are attached to the compression springs, and the other end is attached to the piston rods of the cylinders. The cylinders are connected to the control panel constituting the part of the equipment. The cables are pulled and released by cylinders. The number of cycles for which the cables are to be operated can be pre-set on the panel. The completed operations are registered on the panel, and stop only when the set cycles are completed. The panel of the electronic endurance cycle tester is completely wired up electrically as well as pneumatically, and requires only supply of electricity of 230 V AC, and compressed air at about 5 kgf/cm. sq.