• Bright Engineering Works Private Limited

Steel Forgings

Bright Engineering Works manufactures Steel Forgings. The raw material used in machined components are mild steel, carbon steel, alloy steel and free cutting steel. It can be avail in special prepared edge, natural round edge and square edge.

Designing

• Part along a single, flat plane if possible and if not the parting plan should follow the contour of the part.
• The parting surface should be a plane through the center of the forging and not near an upper or lower edge.
• Adequate draft should be provided; a good guideline is at least 3° for aluminum and 5° to 7° for steel.
• Generous fillets and radii
• Ribs should be low and wide
• The various sections should be balanced to avoid extreme difference in metal flow.
• Full advantage should be taken of fiber flow lines.
• Dimensional tolerances should not be closer than necessary.