Schedule a Call Back
Worm Gear Reduction Units
Worm Gear Reduction Units
The Power Master range of worm gear reduction units are manufactured in different sizes in adopter type as well as solid foot mounting type to transmit minimum 0.05 HP and maximum 90 HP power with selection of correct sizes. The worm is solid with shaft made of high grade alloy steel so as to give hard resisting surface. The worm wheel is made on centrifugally case phosphor bronze rim shrunk and keyed on case iron centre block for bigger units and solid casting for smaller units. The teeth are hobbed on gear hobbing machine. The gear housing is made of close grain graded case iron. Best quality of oil seals are used. Ball or roller bearings are used in worm wheel with ample capacity so that is can take journal and thrust loads.
These are normally available in reduction ratios of 5:1, 10:1, 15:1, 20:1, 30:1, 40:1, 50:1 and 60:1 and 70:1. Also higher ratio from 100:1 to 3000:1 can be given on specific inquiries.Wherever they can be applied in material and construction they are made almost I.S.S 3734-1966 for worm gearing or DIN or latest ISI standard. Every Power Master worm reduction gear unit is guaranteed for `one year’ against manufacturing defects.
Hard water resisting surface, duly case hardened and profile ground on thread grinder. The bearing and oil seal journals are accurately cylindrically ground to give smooth running. Large cooling fins on both sides adequate cooling area improves efficiency.
Products from Panchal Machinery
Products from MACHINE TOOLS, POWER & HAND TOOLS Category
Verified
Verified
Versatile Machining Capability Through Ram Type Milling & Grinding Heads
Deburring, Drilling, Boring, Tapping and Threading Machines
Verified
Verified
